Friday, July 16, 2010

Completed: Detangling a long wig (and preparing it for future project)

There has been some time since the last post. I've been writing a long report about our experiences from Tracon and it is starting to seem like a forever project. I will try to step up and finish it on Sunday or Monday at the latest.

In May I started and experiment with silicon spray and a long wig. I had to put it aside, because we needed to work with costumes for Joxter and Muddler. Yesterday I had a day off so I went back to it. The working was a lot easier, because I had a stand for the wig head. It is actually from my fitting dummy, which I picked up from Yoki's place after... two years? I had planned to chech out the local flee markets for an cheap and old floor lamp, but then I realized that it would just take space and be somewhat unnececessary item laying around. Before I tried to use my table as a platform and my legs to keep the wig head still. Not succesful I assure.

Before, after and bundled.

I was really happy with the result after finishing the whole wig and it looked rather wearable as it was. For my purposes, I wanted to solve the fibers as well as possible. I'm going to use most of the lenght for wefts for a ridiculous ponytail. I also used pretty thich comb, which for some might sound horrible. But really, there were not too much of hair loss and with patience the fibers didn't get streched, which usually causes the wig to look messy.

The fibers doesn't get greasy looking when you take your time with the comb and remember to spray the silicon far enough. I haven't tried how the silicon will react to hairspray and other styling products so I can't guarantee that they will work normally.


After the detangling I prepared the wig for later projects, in other word cut it shorter and stored it and the material for the ponytail. Next week we are going to continue the making of the Snowtroopers and finally finish them. I hope that next week the weather would be bearable. I'm not designed for 32 Celcius for long periods of time. My productivity suffers greatly.


Because I didn't have a pair of helping hands I used yarn to make the cutting little easier.

Red rubberband marks the spot. I took off the gray yarns and cut the ponytail just over the rubberband.

Wig after the excess lenght has been cut out.

Trial for the placement of the base of the ponytail. Needs to be higher.

No comments:

Post a Comment